Be careful, since the lid can be heavy and may break if you drop it.
Boiling water can crack porcelain, so avoid it at all costs! In an emergency, you can empty out a trash can, then use it to carry water to the toilet.
The water may not drain. Check how high the water level is in the bowl to see if you have room to try the treatment again.
If the water looks like it’s about to overflow, stop and consider trying a different treatment. If the water is about to overflow and you don’t want to try something else yet, wait. The water level may go down over time.
If the toilet seems likely to overflow, you may want to avoid flushing. Instead, wait and see if the water level drops or try using a plunger.
The flapper will most likely have a metal chain attached to it. Pull on the chain to lift or lower the flapper. The water inside the tank is clean, so you don’t have to worry about protecting your hands.
Get a funnel plunger from a general store. This type of plunger has a rubber ring hanging down from the suction cup. Sink plungers have no rubber flange on the bell end. This type of plunger may still work, but it isn’t as effective as funnel plungers.
The water in the tank is clean, so you can touch it without getting your hands dirty. You can also pour water in the bowl if you need to. Consider using hot water.
You can test the seal by lifting the plunger. It will feel stuck in place at first, releasing air once it pops off.
Once the air is released, you can safely use the plunger without the risk of serious splashback.
Moving the water into and out of the drainage pipe with equal force increases the chances of the clog breaking up. If you don’t have a plunger, you can instead use a toilet brush you’d normally clean with. [10] X Expert Source James SchuelkeProfessional Plumber Expert Interview. 1 October 2019.
The extra force may dislodge the clog or at least weaken it to make steady plunging more effective.
If you don’t seem to be making progress after regular plunging, you may need an auger or a professional plumber.
Any type of plumbing snake works, but the best type to get is an auger. It is designed for toilets and doesn’t scratch porcelain. You can buy plumbing snakes at most hardware or general stores.
If your snake doesn’t have a crank, rotate it by hand to push it into the clog.
If the wire is clean and empty, it may not have reached the clog. Lower it back into the hole slowly to make sure it goes down the drain.
The plunger should be able to force water down the pipe, lowering the water level in the bowl as it breaks up any clogs still in the pipe. If the water completely drains from the bowl, plunging is optional. However, plunging 2 to 5 times is recommended to force out any clogging material still lingering in the pipes.
If the toilet is still clogged, try snaking the drain and plunging again. If you can’t clear the clog at all, it may be deeper in the drain. You will have to call a plumber.
